ASTM-E2769 2011

$40.63

E2769-11 Standard Test Method for Elastic Modulus by Thermomechanical Analysis Using Three-Point Bending and Controlled Rate of Loading

Published By	Publication Date	Number of Pages
ASTM	2011	5

Guaranteed Safe Checkout

Categories: 29.035.20 - Plastics and rubber insulating materials, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM E2769-11

Historical Standard: Standard Test Method for Elastic Modulus by Thermomechanical Analysis Using Three-Point Bending and Controlled Rate of Loading

ASTM E2769

Scope

1.1 This test method describes the use of linear controlled-rate-of-loading in three-point bending to determine the elastic modulus of isotropic specimens in the form of rectangular bars using a thermomechanical analyzer (TMA).

Note 1—This method is intended to provide results similar to those of Test Methods D790 or D5934 but is performed on a thermomechanical analyzer using smaller test specimens. Until the user demonstrates equivalence, the results of this method shall be considered independent and unrelated to those of Test Methods D790 or D5934.

1.2 This test method provides a means for determining the elastic modulus within the linear region of the stress-strain curves (see Fig. 1). This test is conducted under isothermal temperature conditions from –100 to 300 °C.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 There is no ISO standard equivalent to this test method.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

FIG. 1 Stress-Strain Curve (Linear Region)

Keywords

elastic modulus; modulus of elasticity; stress; strain; thermomechanical analysis

ICS Code

ICS Number Code 29.035.20 (Plastic and rubber insulating materials)

DOI: 10.1520/E2769-11

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Summary of Test Method Significance and Use
2	Interferences Apparatus FIG. 1 FIG. 2
3	Hazards Test Specimens Calibration Conditioning Procedure
4	Calculation Report Precision and Bias Keywords FIG. 3

Additional information

Standard Title	E2769-11 Standard Test Method for Elastic Modulus by Thermomechanical Analysis Using Three-Point Bending and Controlled Rate of Loading
Published Code	ASTM
Publication Date	2011
Pages Count	5
ICS Codes	29.035.20 - Plastics and rubber insulating materials