ASTM-G176:2009 Edition

$40.63

G176-03(2009) Standard Test Method for Ranking Resistance of Plastics to Sliding Wear using Block-on-Ring Wear Test—Cumulative Wear Method

Published By	Publication Date	Number of Pages
ASTM	2009	9

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM G176-03-Reapproved2009

Historical Standard: Standard Test Method for Ranking Resistance of Plastics to Sliding Wear using Block-on-Ring Wear Test—Cumulative Wear Method

ASTM G176

Scope

1.1 This test method covers laboratory procedures for determining the resistance of plastics to sliding wear. The test utilizes a block-on-ring friction and wear testing machine to rank plastics according to their sliding wear characteristics against metals or other solids.

1.2 An important attribute of this test is that it is very flexible. Any material that can be fabricated into, or applied to, blocks and rings can be tested. Thus, the potential materials combinations are endless. In addition, the test can be run with different gaseous atmospheres and elevated temperatures, as desired, to simulate service conditions.

1.3 Wear test results are reported as the volume loss in cubic millimetres for the block and ring. Materials of higher wear resistance will have lower volume loss.

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

block-on-ring; friction; plastics; sliding; wear; wear test; Block-on-ring wear test; Cumulative wear method; Friction/frictional properties; Ranking resistance; Sliding wear test data; Wear testing–plastics

ICS Code

ICS Number Code 19.060 (Mechanical testing)

DOI: 10.1520/G0176-03R09

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Summary of Test Method Significance and Use
2	Apparatus and Test Specimens Reagents Preparation and Calibration of Apparatus Procedure FIG. 1
3	Calculation FIG. 2
4	Report Precision and Bias
5	TABLE 1
6	FIG. 4
7	Typical Test Values (from Interlaboratory Test Experience) Discussion Keywords X1. INTERLABORATORY TEST RESULTS X1.1 X1.2 TABLE 2
8	TABLE X1.1
9	TABLE X1.2

Additional information

Standard Title	G176-03(2009) Standard Test Method for Ranking Resistance of Plastics to Sliding Wear using Block-on-Ring Wear Test—Cumulative Wear Method
Published Code	ASTM
Publication Date	2009
Pages Count	9