BS EN 13348:2016 – TC:2020 Edition
$186.33
Tracked Changes. Copper and copper alloys. Seamless, round copper tubes for medical gases or vacuum
| Published By | Publication Date | Number of Pages |
| BSI | 2020 | 56 |
This European Standard specifies the requirements, sampling, test methods and conditions of delivery for copper tubes. It is applicable to seamless round copper tubes having an outside diameter from 6 mm up to and including 219 mm for pipeline systems under vacuum or for distributing the following medical gases intended to be used at operating pressures up to 2 000 kPa: – oxygen, nitrous oxide, nitrogen, helium, carbon dioxide, xenon; – medical air; – specific mixtures of these above mentioned gases; – air for driving surgical tools; – anaesthetic gases and vapours.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | compares BS EN 13348:2016 |
| 2 | TRACKED CHANGES Text example 1 — indicates added text (in green) |
| 34 | Contents Page |
| 35 | European foreword |
| 37 | Introduction |
| 38 | 1 Scope 2 Normative references |
| 39 | 3 Terms and definitions |
| 40 | 4 Designations 4.1 Material 4.1.1 General 4.1.2 Symbol 4.1.3 Number 4.2 Material condition 4.3 Product |
| 41 | 5 Ordering information 6 Requirements 6.1 Composition 6.2 Mechanical properties |
| 42 | Table 1 — Mechanical properties 6.3 Dimensions and tolerances 6.3.1 General 6.3.2 Nominal dimensions |
| 43 | Table 2 — Nominal outside diameters and wall thicknesses 6.3.3 Tolerances on outside diameter |
| 44 | Table 3 — Tolerances on outside diameter 6.3.4 Tolerance on wall thickness Table 4 — Tolerance on wall thickness 6.3.5 Tolerance on length |
| 45 | 6.4 Freedom from defects 6.5 Surface quality Table 5 — Lubricant residue on the inner surface of the tube 6.6 Bending 6.7 Drift expanding |
| 46 | Table 6 — Testing of bending and drift expanding 7 Sampling Table 7 — Sampling rate |
| 47 | 8 Test methods 8.1 Analysis 8.2 Tensile test 8.3 Hardness test 8.4 Carbon content test 8.5 Bending test Table 8 — Minimum radius of curvature 8.6 Drift-expanding test |
| 48 | 8.7 Freedom from defects test 8.8 Retests 9 Inspection documentation 10 Packaging, marking and form of delivery 10.1 Packaging and marking |
| 49 | 10.2 Form of delivery Table 9 — Recommended form of delivery |
| 50 | Annex A (normative) Marking durability test A.1 Abrasion test A.2 Climatic test |
| 51 | Annex B (normative) Freedom from defects test B.1 Eddy current test Table B.1 — Maximum drill diameters for the reference standard tube B.2 Hydrostatic test Table B.2 — Hydrostatic pressure test |
| 52 | B.3 Pneumatic test |
| 53 | Annex ZA (informative) Relationship between this European Standard and the Essential Requirements of Directive 2014/68/EU aimed to be covered Table ZA.1 — Correspondence between this European Standard and Annex I of Directive 2014/68/EU |
| 54 | Bibliography |
