BS EN 60851-6:2012
$102.76
Winding wires. Test methods – Thermal properties
| Published By | Publication Date | Number of Pages |
| BSI | 2012 | 18 |
This part of IEC 60851 specifies the following tests:
-
Test 9: Heat shock;
-
Test 10: Cut-through;
-
Test 15: Temperature index;
-
Test 21: Loss of mass.
For definitions, general notes on methods of test and the complete series of methods of test for winding wires, see IEC 60851-1.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | English CONTENTS |
| 7 | INTRODUCTION |
| 8 | 1 Scope 2 Normative references 3 Test 9: Heat shock (applicable to enamelled and tape wrapped wire) 3.1 General 3.2 Specimen 3.2.1 Round wire |
| 9 | 3.2.2 Rectangular wire 3.3 Procedure 3.4 Result 4 Test 10: Cut-through (applicable to enamelled round wire with a nominal conductor diameter over 0,100 mm up to and including 1,600 mm and tape wrapped round wire) 4.1 General 4.2 Equipment 4.3 Procedure Table 1 – Magnification |
| 10 | 5 Test 15: Temperature index 6 Test 21: Loss of mass (applicable to enamelled round wire) 6.1 General 6.2 Specimen 6.3 Procedure Table 2 – Loads applied to the crossing point |
| 12 | Figure 1 – Compression device for the cut-through test |
| 13 | Annex A (informative) High temperature failure test (applicable to enamelled round wire) Table A.1 – Test voltage |
| 15 | Bibliography |
Related products
-
BS EN 60851-6:2012
Winding wires. Test methods – Thermal properties Published By Publication Date Number of Pages BSI…
