BS EN 61169-47:2012:2013 Edition
$142.49
Radio-frequency connectors – Sectional specification for radio-frequency coaxial connectors with clamp coupling, typically for use in 75 Ω cable networks (type F-Quick)
| Published By | Publication Date | Number of Pages |
| BSI | 2013 | 24 |
This part of IEC 61169, which is a sectional specification (SS), provides information and rules for the preparation of detail specifications (DS) for RF coaxial connectors with clamp coupling, typically for use in 75 Ω cable networks (type F-Quick).
It describes the interface dimensions with gauging information, electrical and mechanical performance including the mandatory tests selected from IEC 61169-1:1992, applicable to all DS relating to type F-Quick connectors.
This specification indicates the recommended performance characteristics to be considered when writing a DS and covers test schedules and inspection requirements.
NOTE This interface is typically used for indoor connections, which are easily disconnected and reconnected. The typical application is for F-type coaxial receiver leads or F-type coaxial patch cables. The interface may also be known as a Push – On connector.
It is preferred to use the fixed (screwed) connectors type F according to IEC 61169-24:2009.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | CONTENTS |
| 7 | 1 Scope 2 Normative references 3 Interface dimensions 3.1 Dimensions 3.1.1 Common dimensions |
| 8 | 3.1.2 Example of connector “F-Quick” type male plug with resilient outer conductor sleeve (indoor) physical dimensions Figure 1 – Connector “F-Quick” type male plug: General dimensions Table 1 – Connector “F” type male plug (indoor) |
| 9 | 3.1.3 Example of connector “F-Quick” type male plug with slotted outer conductor (indoor) physical dimensions 3.1.4 Example of connector “F-Quick” type male plug with slotted outer conductor and snap ring (indoor) physical dimensions Figure 2 – Example of connector “F-Quick” type male plug with resilient outer conductor sleeve (indoor) Figure 3 – Example of connector “F-Quick” type male plug with slotted outer conductor (indoor) |
| 10 | 3.2 Mechanical gauges Figure 4 – Example of connector “F-Quick” type male plug with slotted outer conductor and snap ring (indoor) Figure 5 – Mechanical gauge |
| 11 | 4 Quality assessment procedures 4.1 General 4.2 Ratings and characteristics Table 2 – Ratings and characteristics (1 of 2) |
| 13 | 4.3 Environmental characteristics for outdoor sockets 4.4 Test schedule and inspection requirements 4.4.1 Acceptance tests 4.4.2 Periodic tests Table 3 – Acceptance tests |
| 14 | Table 4 – Periodic tests (1 of 2) |
| 15 | 4.5 Procedures 4.5.1 Quality conformance inspection 4.5.2 Qualification approval and its maintenance 5 Instructions for preparation of detail specifications 5.1 General |
| 16 | 5.2 Identification of the detail specification 5.3 Identification of the component 5.4 Performance 5.5 Marking, ordering information and related matters 5.6 Selection of tests, test conditions and severities |
| 17 | 5.7 Blank detail specification pro-forma for type F connector |
