BS EN IEC 60317-0-4:2020
$142.49
Specifications for particular types of winding wires – General requirements. Glass-fibre wound, resin or varnish impregnated, bare or enamelled rectangular copper wire
| Published By | Publication Date | Number of Pages |
| BSI | 2020 | 30 |
IEC 60317-0-4:2020 is available as IEC 60317-0-4:2020 RLV which contains the International Standard and its Redline version, showing all changes of the technical content compared to the previous edition.IEC 60317-0-4:2020 specifies general requirements of glass-fibre wound, resin or varnish impregnated, bare or enamelled rectangular copper wire.The range of nominal conductor dimensions is given in 4.1 and the relevant specification sheet. This fourth edition cancels and replaces the third edition published in 2015. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: – addition of dimensional requirements for grade 1 enamelled wire in Table 4; – addition of dielectric breakdown requirements for grade 1 enamelled wire in Table 7. – addition of requirement for the adherence test in 8.2.1 and 8.2.2.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | undefined |
| 5 | Annex ZA(normative)Normative references to international publicationswith their corresponding European publications |
| 7 | English CONTENTS |
| 9 | FOREWORD |
| 11 | INTRODUCTION |
| 12 | 1 Scope 2 Normative references 3 Terms, definitions, general notes and appearance 3.1 Terms and definitions |
| 13 | 3.2 General notes 3.2.1 Methods of test |
| 14 | 3.2.2 Winding wire 3.3 Appearance 4 Dimensions 4.1 Conductor dimensions |
| 15 | Tables Table 1 – Nominal cross-sectional areas of preferred sizes |
| 16 | 4.2 Tolerance on conductor dimensions 4.3 Rounding of corners 4.4 Increase in dimensions due to the insulation Table 2 – Conductor tolerances Table 3 – Corner radii |
| 17 | Table 4 – Increase in dimensions |
| 18 | 4.5 Overall dimensions 4.5.1 Nominal overall dimensions 4.5.2 Minimum overall dimensions 4.5.3 Maximum overall dimensions 5 Electrical resistance 6 Elongation 7 Springiness Table 5 – Elongation |
| 19 | 8 Flexibility and adherence 8.1 Mandrel winding test 8.2 Adherence test 8.2.1 Glass-fibre covered bare wires 8.2.2 Glass-fibre covered enamelled wires 9 Heat shock 10 Cut-through 11 Resistance to abrasion 12 Resistance to solvents 13 Breakdown voltage Table 6 – Mandrel winding |
| 20 | 14 Continuity of insulation 15 Temperature index 16 Resistance to refrigerants 17 Solderability 18 Heat or solvent bonding 19 Dielectric dissipation factor 20 Resistance to transformer oil 21 Loss of mass Table 7 – Breakdown voltage |
| 21 | 23 Pin hole test 30 Packaging |
| 22 | Annex A (informative) Nominal cross-sectional areas for preferred and intermediate sizes Table A.1 – Nominal cross-sectional areas |
| 29 | Bibliography |
