BS EN IEC 63137-1:2019
$142.49
Standard test radio-frequency connectors – Generic specification. General requirements and test methods
| Published By | Publication Date | Number of Pages |
| BSI | 2019 | 30 |
IEC 63137-1:2019 defines general requirements for standard test radio frequency (RF) connectors (grade 0), including terms and definitions, ratings and characteristics, general requirements, test methods, quality assessment procedures, and etc. Standard test radio frequency (RF) connectors (grade 0) are intended to measure grade 1 and grade 2 RF connectors for electrical performances. Typically, a standard test radio frequency (RF) connector (grade 0) is an adapter with one end (normally a precision connector interface) which can be connected with measurement equipment and the other end (normally a standard test connector interface) which can be connected with grade 1 or grade 2 connectors. This specification applies to grade 0 standard test connectors (called connector, hereinafter).
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | undefined |
| 5 | Annex ZA(normative)Normative references to international publicationswith their corresponding European publications |
| 7 | English CONTENTS |
| 9 | FOREWORD |
| 11 | 1 Scope 2 Normative references 3 Terms and definitions |
| 13 | 4 Design and construction 4.1 General 4.2 Materials and finishes 4.3 Connector interface dimensions and gauge |
| 14 | 5 Standards ratings and characteristics 6 IEC type designation 7 Requirements and test methods 7.1 General |
| 15 | 7.2 Visual inspection 7.2.1 Requirements 7.2.2 Inspection procedure 7.3 Dimensions and interchangeability 7.3.1 Requirements 7.3.2 Inspection procedure 7.4 Ellipticity 7.4.1 Requirements 7.4.2 Inspection procedure |
| 16 | 7.5 Characteristic impedance 7.5.1 Requirements 7.5.2 Inspection procedure |
| 17 | 7.6 Electrical inspections 7.6.1 Return loss 7.6.2 Return loss repeatability |
| 18 | 7.6.3 Insertion loss 7.6.4 Insertion loss repeatability |
| 19 | 7.6.5 Phase 7.6.6 Phase repeatability 7.6.7 Screening effectiveness |
| 20 | 7.6.8 Contact resistance 7.6.9 Contact resistance repeatability |
| 21 | 7.6.10 Insulation resistance 7.6.11 Voltage proof |
| 22 | 7.7 Mechanical tests 7.7.1 Insertion force (resilient contacts) 7.7.2 Engagement and separation forces and torques |
| 23 | 7.7.3 Strength of coupling mechanism 7.7.4 Centre contact deflection |
| 24 | 7.7.5 Centre contact captivation 7.7.6 Mechanical endurance |
| 25 | 8 Quality assessment 8.1 General 8.2 First article inspection 8.2.1 First article test samples 8.2.2 Inspection procedure |
| 26 | 8.2.3 Non-compliance 8.2.4 Disposition of test samples Table 1 – First article test program |
| 27 | 8.3 Conformance inspection 8.3.1 Lot-by-lot inspection 8.4 Specifications 8.4.1 Specification structures Table 2 – Group A inspection |
| 28 | 8.4.2 Sectional specification (SS) 8.4.3 Detail specification (DS) 9 Marking 9.1 Marking of component 9.2 Marking and contents of package |
| 29 | Bibliography |
