BS ISO 17885:2015
$198.66
Plastics piping systems. Mechanical fittings for pressure piping systems. Specifications
| Published By | Publication Date | Number of Pages |
| BSI | 2015 | 52 |
This International Standard specifies the requirements and test methods for mechanical fittings intended to join plastic pressure piping systems including transition fittings to metal pipes for the following:
-
supply of gaseous fuels (GAS);
-
supply of water for human consumption (W), including raw water prior to treatment and for the supply of water for general purpose, as well as underground drainage and sewerage under pressure (P);
-
supply of water for irrigation (I);
-
industrial applications (IS).
This International Standard is applicable only to mechanical fittings with operating-temperature and pressure limits as indicated in the relevant systems standards.
A list of International Standard for plastic pipes for which mechanical fittings can be used can be found in Annex A.
Flanges are not covered by this International Standard.
Mechanical fittings for hot and cold water systems inside buildings, as well as for district heating applications, are not covered by this International Standard.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 7 | Foreword |
| 8 | Introduction |
| 9 | 1 Scope 2 Normative references |
| 12 | 3 Terms, definitions, symbols and abbreviated terms 3.1 Terms and definitions |
| 14 | 3.2 Symbols and abbreviated terms 3.2.1 Materials |
| 15 | 3.2.2 Applications 4 Manufacturers declaration for the field of application |
| 16 | 5 Material 5.1 Plastic materials |
| 17 | 5.2 Metals |
| 18 | 5.3 Elastomers |
| 19 | 5.4 Lubricants and/or greases 6 General characteristics 6.1 Appearance 6.2 Colour 6.3 Ultraviolet protection 6.4 Threads 6.5 Transition fittings to metal pipes 6.6 Combined fittings 6.7 Twisting 7 Geometrical characteristics |
| 20 | 8 Physical characteristics 8.1 Evaluation of the MRS value of the plastic material 8.2 Verification of long-term behaviour of the plastic material 8.3 Specific material related characteristics of fitting materials |
| 21 | 8.4 Application-related characteristics 8.4.1 Effect on water quality (W) 8.4.2 Resistance to gas constituents (GAS) |
| 22 | 8.4.3 Chemical resistance of fittings for industrial applications (IS) 9 Performance requirements 9.1 General |
| 23 | 9.2 Pressure resistance of the fitting body 9.2.1 Preparation of test piece 9.2.2 Testing of pressure resistance 9.3 Fitting assemblies 9.3.1 Preparation of test assemblies 9.3.2 Test scheme |
| 25 | 9.3.3 Requirements |
| 35 | 10 Marking 11 Packaging |
| 36 | Annex A (informative) List of standards |
| 37 | Annex B (normative) Stiffener requirements |
| 38 | Annex C (normative) Test pressure of materials and fitting bodies |
| 40 | Annex D (normative) Physical characteristics of fitting materials |
| 45 | Annex E (normative) Resistance to gas constituents |
| 46 | Annex F (normative) Test stresses |
| 48 | Annex G (normative) Cyclic test procedure |
| 49 | Bibliography |
