IEEE C93.3 2017
$33.04
IEEE Standard Requirements for Power-Line Carrier Line Traps (30 kHz to 500 kHz)
| Published By | Publication Date | Number of Pages |
| IEEE | 2017 | 46 |
New IEEE Standard – Active. Line traps inserted into a power line to provide a high impedance at power-line-carrier frequencies (30 kHz to 500 kHz) are covered in this standard. The purpose is to isolate the carrier signal from system impedance changes due to faults or switching behind the point of insertion, and to guide the signal in the proper direction. The standard covers line traps in which the main coil is designed as a single-phase, air-cooled inductor of the dry type.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | IEEE Std C93.3™-2017 Front cover |
| 2 | Title page |
| 4 | Important Notices and Disclaimers Concerning IEEE Standards Documents |
| 7 | Participants |
| 9 | Introduction |
| 10 | Contents |
| 11 | 1. Overview 1.1 Scope 1.2 Purpose 2. Normative references |
| 12 | 3. Definitions, acronyms, and abbreviations 3.1 Definitions |
| 13 | 3.2 Acronyms and abbreviations |
| 14 | 4. Service conditions 4.1 Usual service conditions 4.2 Unusual service conditions |
| 15 | 5. Ratings 5.1 General ratings |
| 18 | 5.2 Rating for tuned type line traps |
| 19 | 6. Testing 6.1 General |
| 21 | 6.2 Design test procedures |
| 28 | 6.3 Production test procedures 7. Manufacturing/design requirements 7.1 Mounting |
| 29 | 7.2 Terminals 7.3 Tuning and protective device location and mounting 7.4 Bird barriers 7.5 Nameplate markings for the main coil |
| 30 | 7.6 Nameplate markings for the tuning device |
| 31 | Annex A (informative) Guide for emergency overload current capability of line traps A.1 Line traps and emergency overload current capability |
| 35 | A.2 Calculation of line trap overload ratings sample calculations |
| 38 | A.3 Insulating materials |
| 39 | Annex B (informative) Loss measurement at power frequency |
| 40 | Annex C (informative) Terminal orientation and construction C.1 Terminal orientation examples |
| 41 | C.2 Schematic |
| 43 | Annex D (informative) Typical fixed wideband bandwidth ranges |
| 45 | Annex E (informative) Bibliography |
| 46 | Back cover |
Related products
-
IEEE C93.3-2017
IEEE Standard Requirements for Power-Line Carrier Line Traps (30 kHz to 500 kHz) Published By…
