TIA/EIA-334-C:2000 (R2014)

$26.00

Signal Quality at Interface Between Data Terminal Equipment and Synchronous Data Circuit – Terminating Equipment for Serial Data Transmission

Published By	Publication Date	Number of Pages
TIA	2000	24

Guaranteed Safe Checkout

Category: TIA

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

This Standard is applicable to the exchange of serial binary
data signals and timing signals across the interface between Data
Terminal Equipment (DTE) and synchronous Data Circuit-terminating
Equipment (DCE). The DCE is considered to be synchronous if the
timing signal circuits are required at the transmitting terminal or
the receiving terminal, or both. The signal quality requirement is
limited to synchronous transmission at the interface with
synchronous DCEs. Signal quality pertaining to asynchronous DTEs is
not part of this Standard.

The interfaces referred to in this Standard conform to TIA/EIA
standards:

TIA/EIA-232-F TIA/EIA-530-A together with TIA/EIA-422-B
electrical characteristics

TIA/EIA-687 together with TIA/EIA-423-B electrical
characteristics

TIA/EIA-723 together with TIA/EIA-694 electrical
characteristics

This Standard specifies signal quality in relation to jitter,
duty cycle, and frequency accuracy of timing signals and time
displacement between data signals and timing signals. Electrical
specifications for the signals are not part of this Standard but
are part of the reference interface specifications.

This Standard is of particular importance when the equipments in
a system are furnished by different organizations. It does not
attempt to indicate what action, if any, is to be taken if the
limits are not met, but it is intended to provide a basis for
agreement between the parties involved.

This Standard does not describe any requirements for error
performance for either a complete system or any system components.
It should not be assumed that compliance with this Standard will
produce error rates that are acceptable in any particular
application.

Any equipment which is represented as complying with this
Standard shall meet the applicable specifications within the range
of those factors which are described as appropriate for the normal
operation of the equipment, such as primary power voltage and
frequency, ambient temperature, or humidity.

This Standard may also be used for DTE to DTE direct
connections

Additional information