🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASTM-A367 2017

ASTM-A367 2017

$35.75

A367-11(2017) Standard Test Methods of Chill Testing of Cast Iron

Published By Publication Date Number of Pages
ASTM 2017 4
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM A367-11-Reapproved2017

Historical Standard: Standard Test Methods of Chill Testing of Cast Iron

ASTM A367

Scope

1.1 These test methods of chill testing apply to gray irons that are to be free of chill in the casting and to chilled irons that are to have a specific depth of chill in the casting. Two test methods of determining the chilling tendencies of cast iron are covered as follows. For many applications, either test method will be satisfactory if test pieces of the proper dimensions are selected.

1.1.1 Test Method A, Wedge Test—This test is generally better adapted to the higher-strength gray irons. The accelerated cooling rate to induce the formation of a chill is brought about through the design of the test specimen. This test method is simpler than Test Method B since maintenance of chill blocks or plates is not necessary.

1.1.2 Test Method B, Chill Test—This test is better adapted to the softer grades of gray iron and should be used if the casting is to have a specified depth of chill. The chill in this type of test is induced by casting one edge of the test specimen against a metal or graphite chilled plate or block.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.2.1 The metric equivalency charts in Figs. 1 and 2 are provided for information only.

FIG. 1 Dimensions for Test Wedges

FIG. 2 Recommended Dimensions for Test Method B Chill Test Specimens

(A) T/2 to 2T.

Note 1—Casting to be made in a dry sand core.

Note 2—Allow 3/4 in. of sand on all sides.

Metric Equivalents

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

ICS Code

ICS Number Code 77.140.80 (Iron and steel castings)

DOI: 10.1520/A0367-11R17

ASTM-A367 2017
$35.75