ASTM-A385 2008

$40.63

A385-08 Standard Practice for Providing High-Quality Zinc Coatings (Hot-Dip)

Published By	Publication Date	Number of Pages
ASTM	2008	9

Guaranteed Safe Checkout

Categories: 25.220.40 - Metallic coatings, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM A385-08

Historical Standard: Standard Practice for Providing High-Quality Zinc Coatings (Hot-Dip)

ASTM A385

Scope

1.1 This practice covers the precautions that should be taken to obtain high-quality hot-dip galvanized coatings.

1.2 Where experience on a specific product indicates a relaxing of any provision, the mutually acceptable change shall be a matter for agreement between the manufacturer and purchaser.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

Keywords

coatings-zinc; galvanized coatings; steel products-metallic coated; zinc coatings-steel products; Hot-dip (galvanized) coatings; Iron products (general)–zinc-coated (hot-dip galvanized); Quality assurance (QA)–metals; Steel forgings; Steel hardware–zinc coatings; Steel plate (zinc-coated (galvanized)); Steel strip–zinc coatings; Structural steel (SS); Wax coatings; Zinc-coated steel castings; Zinc-coated steel products

ICS Code

ICS Number Code 25.220.40 (Metallic coatings)

DOI: 10.1520/A0385-08

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Steel Selection
2	Assemblies of Different Materials or Different Surfaces or Both Overlapping or Contacting Surfaces FIG. 1 FIG. 2
3	Sheet Steel Rolled Over a Wire or Rod Stiffener Weld Flux Removal and Welding Rods Flame Cut Cope Edges Preparation Cold Forming Before Galvanizing Shearing, Cutting and Punching Before Galvanizing Warpage and Distortion Design Recommendations for Providing for the Free Flow of Cleaning Solutions, Fluxes, Air, and Zinc TABLE 1 TABLE 2 FIG. 3 FIG. 4
4	Moving Parts Marking for Identification Galvanized Steel in Concrete Galvanized Nuts, Bolts, and Tapped Holes in Galvanized Products FIG. 5 FIG. 6
5	Critical Dimensions FIG. 7 FIG. 8
6	Keywords FIG. 9
7	FIG. 10
8	FIG. 11 FIG. 12

Additional information

Standard Title	A385-08 Standard Practice for Providing High-Quality Zinc Coatings (Hot-Dip)
Published Code	ASTM
Publication Date	2008
Pages Count	9
ICS Codes	25.220.40 - Metallic coatings