ASTM-C29 2009

$40.63

C29/C29M-09 Standard Test Method for Bulk Density (“Unit Weight”) and Voids in Aggregate

Published By	Publication Date	Number of Pages
ASTM	2009	5

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM C29/C29M-09

Historical Standard: Standard Test Method for Bulk Density (“Unit Weight”) and Voids in Aggregate

ASTM C29/C29M

Scope

1.1 This test method covers the determination of bulk density (“unit weight”) of aggregate in a compacted or loose condition, and calculated voids between particles in fine, coarse, or mixed aggregates based on the same determination. This test method is applicable to aggregates not exceeding 125 mm [5 in.] in nominal maximum size.

Note 1—Unit weight is the traditional terminology used to describe the property determined by this test method, which is weight per unit volume (more correctly, mass per unit volume or density).

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard, as appropriate for a specification with which this test method is used. An exception is with regard to sieve sizes and nominal size of aggregate, in which the SI values are the standard as stated in Specification E11. Within the text, inch-pound units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

aggregates; bulk density; coarse aggregate; density; fine aggregate; unit weight; voids in aggregates; Coarse aggregate; Fine aggregate; Unit weight; Void content; Weight–concrete/aggregates

ICS Code

ICS Number Code 19.060 (Mechanical testing)

DOI: 10.1520/C0029_C0029M-09

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology
2	Significance and Use Apparatus Sampling Test Sample Calibration of Measure TABLE 1 TABLE 2
3	Selection of Procedure Rodding Procedure Jigging Procedure Shoveling Procedure Calculation TABLE 3
4	Report Precision and Bias Keywords

Additional information

Standard Title	C29/C29M-09 Standard Test Method for Bulk Density ("Unit Weight") and Voids in Aggregate
Published Code	ASTM
Publication Date	2009
Pages Count	5