ASTM-D2990 2017(Redline)

$58.50

D2990-17 Standard Test Methods for Tensile, Compressive, and Flexural Creep and Creep-Rupture of Plastics (Redline)

Published By	Publication Date	Number of Pages
ASTM	2017	26

Guaranteed Safe Checkout

Categories: 83.080.01 - Plastics in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D2990-17

Redline Standard: Standard Test Methods for Tensile, Compressive, and Flexural Creep and Creep-Rupture of Plastics

ASTM D2990

Scope

1.1 These test methods cover the determination of tensile and compressive creep and creep-rupture of plastics under specified environmental conditions (see 3.2).

1.2 In these test methods three-point loading, as described in Test Methods D790, is used for measurement of creep in flexure. However, four-point loading using the equipment and principles described in D6272 is also permitted as an option.

1.3 For measurements of creep-rupture, tension is the preferred stress mode because for some ductile plastics rupture does not occur in flexure or compression.

1.4 Test data obtained by these test methods are relevant and appropriate for use in engineering design.

1.5 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific warning statement is given in 6.8.2.

Note 1: This standard and ISO 899 Parts 1 and 2 address the same subject matter, but differ in technical content (and results cannot be directly compared between the two test methods). ISO 899 Part 1 addresses tensile creep and creep to rupture and ISO 899 Part 2 addresses flexural creep. Compressive creep is not addressed in ISO 899.

Keywords

creep; creep-rupture; plastics;

ICS Code

ICS Number Code 83.080.01 (Plast in general)

DOI: 10.1520/D2990-17

Additional information

Standard Title	D2990-17 Standard Test Methods for Tensile, Compressive, and Flexural Creep and Creep-Rupture of Plastics (Redline)
Published Code	ASTM
Publication Date	2017
Pages Count	26
ICS Codes	83.080.01 - Plastics in general