ASTM-D3143:2008 Edition

$40.63

D3143-08 Standard Test Method for Flash Point of Cutback Asphalt with Tag Open-Cup Apparatus

Published By	Publication Date	Number of Pages
ASTM	2008	6

Guaranteed Safe Checkout

Categories: 13.220.50 - Fire-resistance of building materials and elements, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D3143-08

Historical Standard: Standard Test Method for Flash Point of Cutback Asphalt with Tag Open-Cup Apparatus

ASTM D3143

Scope

1.1 This test method covers the determination of flash points by the Tag Open-Cup Apparatus of cutback asphalts having flash points of less than 93°C (200°F).

Note 1—Specifications commonly designate the Cleveland Open Cup (ASTM D 92–IP 36) Method for asphalt cements and cutback asphalts having flash points above 79°C (175°F).

Note 2—This procedure follows in general the procedure outlined in Test Method D 1310, but is restricted to cutback asphalt having flash points of less than 93°C (200°F).

1.2 The values stated in SI units are the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This standard should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use.

Keywords

cutback asphalt; flash point; open cup; tag; Asphalts–cutback; Cutback asphalt; Flash point; Open-cup flash point methods; Tag open-cup tester

ICS Code

ICS Number Code 13.220.50 (Fire-resistance of building materials and elements)

DOI: 10.1520/D3143-08

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Summary of Test Method Significance and Use Apparatus
2	Reagents and Materials Sampling Assembly and Preparation of Apparatus Calibration and Standardization Procedure Calculations
3	Report Precision and Bias Keywords A1. APPARATUS A1.1
4	FIG. A1.1
5	FIG. A1.2 FIG. A1.3

Additional information

Standard Title	D3143-08 Standard Test Method for Flash Point of Cutback Asphalt with Tag Open-Cup Apparatus
Published Code	ASTM
Publication Date	2008
Pages Count	6
ICS Codes	13.220.50 - Fire-resistance of building materials and elements