ASTM-D5485 2021(Redline)

$44.96

D5485-21 Standard Test Method for Determining Corrosive Effect of Combustion Products Using the Cone Corrosimeter (Redline)

Published By	Publication Date	Number of Pages
ASTM	2021

Guaranteed Safe Checkout

Categories: 13.040.40 - Stationary source emissions, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D5485-21

Redline Standard: Standard Test Method for Determining Corrosive Effect of Combustion Products Using the Cone Corrosimeter

ASTM D5485

Scope

1.1 This fire-test-response standard measures the corrosive effect by loss of metal from the combustion products of materials, components, or products.

1.2 This test method provides corrosion results of product and material specimens limited to a maximum size of 100 by 100 mm in area and 50 mm thick.

1.3 Additional information regarding the targets, the test conditions, and test limitations is provided in Annex A1.

1.4 The results of this test method have not been investigated with respect to correlation to actual fires.

1.5 An ISO standard exists, as developed by ISO TC 61 (Plastics), subcommittee 4 (on burning behavior), which is technically very similar to this test method and is designated ISO 11907-4.

1.6 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. (See IEEE/ASTM SI10.)

1.7 This standard measures and describes the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.

1.8 Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.

1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.

1.10 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

cone calorimeter; cone corrosimeter; conical heater; corrosion damage; corrosive potency; corrosivity; electrical insulations or coverings; fire; fire test response; ignition; radiant heat; smoke corrosivity ;

ICS Code

ICS Number Code 13.040.40 (Stationary source emissions)

DOI: 10.1520/D5485-21

Additional information

Standard Title	D5485-21 Standard Test Method for Determining Corrosive Effect of Combustion Products Using the Cone Corrosimeter (Redline)
Published Code	ASTM
Publication Date	2021
ICS Codes	13.040.40 - Stationary source emissions