ASTM-D7834 2019
$29.79
D7834-13(2019) Standard Test Method for Filling Material Shedding of Paint Brushes
| Published By | Publication Date | Number of Pages |
| ASTM | 2019 | 2 |
ASTM D7834-13-Reapproved2019
Active Standard: Standard Test Method for Filling Material Shedding of Paint Brushes
ASTM D7834
Scope
1.1 This test method describes the procedure for testing the shedding properties of both natural bristle and synthetic filament paint brushes (referred as filling material).
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
brush ferrule; brush filling material; length clear;
ICS Code
ICS Number Code 87.100 (Paint coating equipment)
DOI: 10.1520/D7834-13R19
