ASTM-D8509/D8509M 2023

$37.38

D8509/D8509M-23 Standard Guide for Test Method Selection and Test Specimen Design for Bolted Joint Related Properties

Published By	Publication Date	Number of Pages
ASTM	2023	16

Guaranteed Safe Checkout

Categories: 21.060.01 - Fasteners in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D8509/D8509M-23

Active Standard: Standard Guide for Test Method Selection and Test Specimen Design for Bolted Joint Related Properties

ASTM D8509/D8509M

Scope

1.1 This guide covers the test method selection and associated test specimen design to produce test data to be used for typical bolted joint analyses. These test methods are limited to use with multi-directional polymer matrix composite laminates reinforced by high-modulus fibers. This standard is intended to be used by persons requesting these test types.

1.2 Test requestors designing these specimens need to be familiar with the referenced Test Method and Practice standards, CMH-17 Volume 3 Chapter 11, and the stress analysis methods that will use the resulting design data.

1.3 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.3.1 Within the text the inch-pound units are shown in brackets.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

bearing fatigue; bearing properties; bearing strength; bearing/bypass properties; bolted joints; bypass strength; composite materials; compression testing; fastener; fastener pull-through; filled-hole compressive strength; filled-hole tensile strength; hole elongation; open-hole compressive strength; open-hole fatigue; open-hole tensile strength; out-of-plane loading; tension testing;

ICS Code

ICS Number Code 21.060.01 (Fasteners in general)

DOI: 10.1520/D8509_D8509M-23

Additional information

Standard Title	D8509/D8509M-23 Standard Guide for Test Method Selection and Test Specimen Design for Bolted Joint Related Properties
Published Code	ASTM
Publication Date	2023
Pages Count	16
ICS Codes	21.060.01 - Fasteners in general