Shopping Cart

No products in the cart.

ASTM-D957 2021(Redline)

$35.75

D957-21 Standard Practice for Determining Surface Temperature of Molds for Plastics (Redline)

Published By Publication Date Number of Pages
ASTM 2021
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. Weā€™re here to assist you 24/7.
Email:[email protected]

ASTM D957-21

Redline Standard: Standard Practice for Determining Surface Temperature of Molds for Plastics

ASTM D957

Scope

1.1 This practice is intended for determining the temperature at a specified point or points on the surface of the cavity and base of a mold for plastics. By determining the temperature at as many points as deemed necessary, the overall temperature condition of the surface can be determined.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1: There is no known ISO equivalent to this standard.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

base; cavity; mold temperature; pyrometer;

ICS Code

ICS Number Code 83.200 ()

DOI: 10.1520/D0957-21

ASTM-D957 2021
$35.75