Shopping Cart

No products in the cart.

ASTM-F1430:2003 Edition

$40.63

F1430-03e1 Standard Test Method for Acoustic Emission Testing of Insulated and Non-Insulated Aerial Personnel Devices with Supplemental Load Handling Attachments

Published By Publication Date Number of Pages
ASTM 2003 10
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM F1430-03e1

Historical Standard: Standard Test Method for Acoustic Emission Testing of Insulated and Non-Insulated Aerial Personnel Devices with Supplemental Load Handling Attachments

ASTM F1430

Scope

1.1 This test method describes a procedure for acoustic emission (AE) testing of aerial personnel devices (APDs) with supplemental load handling attachments.

1.1.1 Equipment Covered—This test method covers the following types of vehicle-mounted aerial personnel devices with supplemental load handling attachments:

1.1.1.1 Extensible-boom APDs,

1.1.1.2 Articulating-boom APDs, and

1.1.1.3 Any combination of 1.1.1.1 and 1.1.1.2.

1.1.2 Equipment Not Covered—This test method does not cover any of the following equipment:

1.1.2.1 Insulated aerial personnel devices without supplemental load handling attachments,

Digger-derricks with platform,

1.1.2.3 Cranes with platform, and

1.1.2.4 Aerial devices with load-lifting capabilities located anywhere other than adjacent to the platform.

Note 1—This test method is not intended to be a stand-alone NDT method for the verification of the structural integrity of an aerial device. Other NDT methods should be used to supplement the results.

1.2 The AE test method is used to detect and area-locate emission sources. Verification of emission sources may require the use of other nondestructive test (NDT) methods, such as radiography, ultrasonics, magnetic particle, liquid penetrant, and visual inspection. ( Warning—This test method requires that external loads be applied to the superstructure of the vehicle under test. During the test, caution must be taken to safeguard personnel and equipment against unexpected failure or instability of the vehicle or components.)

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

acoutic, emission; AE; aerial; devices; platforms

ICS Code

ICS Number Code 17.140.01 (Acoustic measurements and noise abatement in general)

DOI: 10.1520/F1430-03E01

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
3 FIG. 1
4 Summary of Test Method
Significance and Use
FIG. 2
5 Personnel Qualifications
Acoustic Emission Instrumentation
Test Preparation
Acoustic Emission (AE) Instrumentation System Performance Check
System Calibration
TABLE 1
TABLE 2
6 Procedure
FIG. 3
FIG. 4
7 FIG. 5
8 Report
FIG. 6
9 Precision and Bias
A1. INSTRUMENT PERFORMANCE REQUIREMENTS
A1.1 Sensors
A1.2 Signal Cable
A1.3 Preamplifier
A1.4 Filters
A1.5 Power-Signal Cable
A1.6 Main Amplifiers
A1.7 Main Processor
10 X1. ALTERNATIVE LOADING SEQUENCES
X1.1
ASTM-F1430
$40.63