ASTM-F2307 2003
$40.63
F2307-03 Standard Specification for Series 10 Poly(Vinyl Chloride) (PVC) Closed Profile Gravity Pipe and Fittings Based on Controlled Inside Diameter (Withdrawn 2011)
| Published By | Publication Date | Number of Pages |
| ASTM | 2003 | 5 |
ASTM F2307-03
Withdrawn Standard: Standard Specification for Series 10 Poly(Vinyl Chloride) (PVC) Closed Profile Gravity Pipe and Fittings Based on Controlled Inside Diameter (Withdrawn 2011)
ASTM F2307
Scope
1.1 This specification covers requirements for 10 psi pipe stiffness poly(vinyl chloride) (PVC) closed profile sewer pipe and fittings with integral bell and elastomeric seal joints or plain end pipe with couplings in sizes (18 to 60 in.) based on a controlled inside diameter.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The following safety hazard caveat pertains only to the test methods portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1—Pipe and fittings produced to this specification should be installed in accordance with Practice D 2321.
Keywords
closed profile wall; PVC; sewer pipe
ICS Code
ICS Number Code 23.040.20 (Plastic pipes)
DOI: 10.1520/F2307-03
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology Significance and Use |
| 2 | Material Joining Systems Requirements FIG. 1 TABLE 1 |
| 3 | Test Methods TABLE 2 FIG. 2 |
| 4 | Retest and Rejection Marking Inspection Certification TABLE 3 TABLE 4 |
| 5 | Quality Assurance Delivery Keywords |
