ASTM-F2790 2010

$40.63

F2790-10 Standard Practice for Static and Dynamic Characterization of Motion Preserving Lumbar Total Facet Prostheses

Published By	Publication Date	Number of Pages
ASTM	2010	9

Guaranteed Safe Checkout

Categories: 11.040.40 - Implants for surgery, prosthetics and orthotics, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM F2790-10

Historical Standard: Standard Practice for Static and Dynamic Characterization of Motion Preserving Lumbar Total Facet Prostheses

ASTM F2790

Scope

1.1 This practice provides guidance for the static and dynamic testing of Lumbar Total Facet Prostheses (FP). These implants are intended to allow motion and lend support to one or more functional spinal unit(s) through replacement of the natural facets.

1.2 These test methods are intended to provide a basis for the mechanical comparison among past, present, and future non-biologic FP. These test methods allow comparison of devices with different methods of application to the lumbar spine. These test methods are intended to enable the user to mechanically compare devices and do not purport to provide performance standards for them.

1.3 These test methods describe static and dynamic tests by specifying load types and specific methods of applying these loads.

1.4 These test methods do not purport to address all clinically relevant failure modes for FP, some of which will be device specific. For example, these test methods do not address implant wear resistance under expected in vivo loads and motions. In addition, the biologic response to wear debris is not addressed in these test methods.

1.5 Requirements are established for measuring displacements and evaluating the stiffness of FP.

1.6 Some devices may not be testable in all test configurations.

1.7 The values stated in SI units are to be regarded as the standard with the exception of angular measurements, which may be reported in terms of either degrees or radians.

1.8 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

Keywords

dynamic stabilization; dynamic test; facet arthroplasty; posterior instrumentation; spinal implants; static test

ICS Code

ICS Number Code 11.040.40 (Implants for surgery, prothetics and orthotics)

DOI: 10.1520/F2790-10

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology
2	FIG. 1 FIG. 2
3	Summary of Practice Significance and Use FIG. 3
4	Apparatus and Setup FIG. 4
5	Sampling Procedure for Static Tests Procedure for Fatigue Tests
6	Precision and Bias Keywords X1. STATEMENT OF RATIONALE FOR TEST METHODS X1.1 X1.2 X1.3 X1.4
7	X1.5 X1.6 FIG. X1.1
8	FIG. X1.2 FIG. X1.3 TABLE X1.1

Additional information

Standard Title	F2790-10 Standard Practice for Static and Dynamic Characterization of Motion Preserving Lumbar Total Facet Prostheses
Published Code	ASTM
Publication Date	2010
Pages Count	9
ICS Codes	11.040.40 - Implants for surgery, prosthetics and orthotics