ASTM-F606/F606M 2019

$44.96

F606/F606M-19 Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets

Published By	Publication Date	Number of Pages
ASTM	2019	19

Guaranteed Safe Checkout

Categories: 21.060.01 - Fasteners in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM F606/F606M-19

Historical Standard: Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets

ASTM F606/F606M

Scope

1.1 These test methods cover establishment of procedures for conducting tests to determine the mechanical properties of externally and internally threaded fasteners, washers, direct tension indicators, and rivets.

1.2 Property requirements and the applicable tests for their determination are specified in individual product standards. In those instances where the testing requirements are unique or at variance with these standard procedures, the product standard shall specify the controlling testing requirements. In the absence of any specified test requirement(s), these test methods shall apply.

1.3 These test methods describe mechanical tests for determining the following properties:

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

Note 1: The values are stated in inch-pound for inch fasteners and SI metric units for metric fasteners.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

compression load; hardness; proof load; properties; tensile; testing; yield;

ICS Code

ICS Number Code 21.060.01 (Fasteners in general)

DOI: 10.1520/F0606_F0606M-19

Additional information

Product Hardness	6.1
Test Method for Determining Decarburization and Carburization	8
Direct Tension Indicators	5.5
For Externally Threaded Fasteners:	3
Stainless Steel and Nonferrous Washers	5.4
Cone Proof Load Test	4.3
Carburized Washers	5.3
Product Hardness-General Requirements	5.1
For Washers and Direct Tension Indicators:	5
Test for Embrittlement of Metallic-Coated Externally Threaded Fasteners	7
Proof Load Test	4.2
Axial Tension Testing of Full-Size Product	3.4
Proof Load	3.2.1
Compression Load	5.6
Method 1, Length Measurement	3.2.3
Total Extension at Fracture Test Single Sheer Test	3.7 3.8
Through Hardened Washers	5.2
For Rivets:	6
For Internally Threaded Fasteners:	4
Wedge Tension Testing of Full-Size Product	3.5
Method 3, Uniform Hardness	3.2.5
Tension Testing of Machined Test Specimens	3.6
Method 2, Yield Strength	3.2.4
	Section
ICS Codes	21.060.01 - Fasteners in general