BS ISO 16463:2014
$142.49
Polycristalline diamond inserts, tipped. Dimensions, types
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 24 |
This International Standard applies to inserts with insert shapes in accordance with ISO 883 and ISO 6987, tipped with polycrystalline diamond (DP).
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Section sec_1 Section sec_2 Section sec_3 Section sec_3.1 Section sec_3.2 Section sec_3.3 Section sec_3.4 Section sec_3.5 1 Scope 2 Normative references 3 Insert shapes and design 3.1 Insert shapes 3.2 Normal clearance, αn 3.3 Cutting edge corner 3.4 Tolerance class 3.5 Design of cutting edges |
| 8 | Section sec_3.6 Section sec_4 Section sec_4.1 Section sec_4.2 Section sec_4.3 Section sec_5 Section sec_5.1 3.6 Insert type 4 Designation 4.1 General 4.2 Designation of a tipped insert for turning 4.3 Designation of a tipped insert for milling 5 Dimensions 5.1 Insert shape T with fixing hole (inserts for turning) |
| 9 | Figure fig_1 Table tab_1 |
| 10 | Section sec_5.2 Figure fig_2 Table tab_2 5.2 Insert shape T without fixing hole (inserts for turning) |
| 11 | Section sec_5.3 Figure fig_3 Table tab_3 Section sec_5.4 5.3 Insert shape S with fixing hole (inserts for turning) 5.4 Insert shape S without fixing hole (inserts for turning) |
| 12 | Figure fig_4 Table tab_4 Section sec_5.5 Figure fig_5 5.5 Insert shape C with fixing hole (inserts for turning) |
| 13 | Table tab_5 |
| 14 | Section sec_5.6 Figure fig_6 Table tab_6 Section sec_5.7 Figure fig_7 5.6 Insert shape D with fixing hole (inserts for turning) 5.7 Insert shape V with fixing hole (inserts for turning) |
| 15 | Table tab_7 Section sec_5.8 Figure fig_8 5.8 Insert shape S with fixing hole (inserts for milling) |
| 16 | Table tab_8 Section sec_5.9 Figure fig_9 Table tab_9 Section sec_5.10 5.9 Insert shape C with fixing hole (inserts for milling) 5.10 Insert shape W with fixing hole (inserts for turning) |
| 17 | Figure fig_10 Table tab_10 Section sec_6 Section sec_6.1 Section sec_6.2 6 Cutting edge length, l1, of tipped inserts 6.1 General 6.2 Inserts with radius |
| 18 | Table tab_a Figure fig_11 Section sec_6.3 Table tab_b Figure fig_12 Table tab_11 Section sec_7 6.3 Inserts with wiper edge 7 Base material, cutting material |
| 19 | Section sec_8 Section sec_9 8 Measurements 9 Marking |
| 20 | Annex sec_A Table tab_A.1 Annex A (informative) Relationship between designations in ISO 16463 and ISO/TS 13399-2 |
| 21 | Table tab_A.1___1 |
