BS ISO 2982-1:2013
$102.76
Rolling bearings. Accessories – Dimensions for adapter sleeve assemblies and withdrawal sleeves
| Published By | Publication Date | Number of Pages |
| BSI | 2013 | 18 |
This part of ISO 2982 specifies:
-
boundary dimensions of adapter sleeves with taper 1:12 and withdrawal sleeves with tapers 1:12 and 1:30 for rolling bearings of a number of dimension series as specified in ISO 15;
-
the outside diameter of suitable locknuts;
-
distance from bearing small bore face to outer face of locknut;
-
distance from bearing small bore face to outer face of bolt head;
-
overall length of withdrawal sleeve and bearing ring.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Section sec_1 Section sec_2 Section sec_3 1 Scope 2 Normative references 3 Terms and definitions |
| 8 | Section sec_4 Figure fig_1 4 Symbols |
| 9 | Section sec_5 Section sec_5.1 Section sec_5.2 Table tab_1 5 Dimensions 5.1 General 5.2 Adapter sleeve assemblies with taper 1:12 |
| 10 | Table tab_2 |
| 11 | Table tab_3 Section sec_5.3 5.3 Withdrawal sleeves with taper 1:12 |
| 12 | Table tab_4 |
| 13 | Section sec_5.4 5.4 Withdrawal sleeves with taper 1:30 |
| 14 | Table tab_5 |
