BS ISO 6106:2013
$102.76
Abrasive products. Checking the grain size of superabrasives
| Published By | Publication Date | Number of Pages |
| BSI | 2013 | 18 |
This International Standard specifies a method for determining or checking the grain size of superabrasives (diamond or cubic boron nitride) as used for the manufacture of industrial products, such as grinding wheels and saws. It is applicable to grain size designations as defined in Tables 2 and 3.
This International Standard describes the grain size designations, the size limits, the sieves for use in determining them and the procedure to be adopted for checking the grain size exclusive of any coating.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Section sec_1 Section sec_2 Section sec_3 Section sec_4 Section sec_4.1 Section sec_4.2 1 Scope 2 Normative references 3 Terms and definitions 4 Apparatus 4.1 Sieving machine 4.2 Sieves |
| 8 | Table tab_1 Section sec_4.3 Section sec_4.4 Section sec_4.5 4.3 Sampling the batch 4.4 Balance 4.5 Timer |
| 9 | Section sec_5 Section sec_6 Section sec_6.1 Section sec_6.2 Section sec_6.3 Section sec_7 Section sec_7.1 Section sec_7.2 5 Test conditions 6 Test sieving 6.1 Sampling 6.2 Preparation for sieving 6.3 Sieving procedure 7 Evaluation 7.1 Weighing sieved fractions 7.2 Calculation of results |
| 10 | Section sec_8 Section sec_8.1 Section sec_8.2 Section sec_8.3 Section sec_9 8 Designation and grading limits 8.1 General 8.2 Grain sizes 8.3 Designation 9 Example showing the use of Table 2 |
| 11 | Table tab_2 |
| 12 | Table tab_3 |
| 13 | Annex sec_A Annex sec_A.1 Annex sec_A.2 Figure fig_A.1 Annex sec_A.3 Annex A (normative) Adaptors for 75 mm sieves |
| 14 | Figure fig_A.2 |
| 15 | Reference ref_1 Bibliography |
